In Vitro Buffering Capacity Changes of Seven Commodities Under Controlled Moisture and Heating Conditions

¹ Department of Animal Science, University of California, Davis 95616

Effects of adding 0 or .25 g of water/g of feed and heating for 0, 20, or 40 h at 100°C on buffering capacity of beet pulp, almond hulls, alfalfa hay, oat hay, wheat bran, oat bran, and barley were determined in vitro. Feeds were examined for ash, N, NDF, ADF, acid detergent lignin, total buffering capacity (pH 4 to 9), and physiological buffering capacity (pH 5.5 to 7). Minerals were measured at 0 g of water/g of feed, 0 h of heat and at .25 g of water/g of feed, 40 h of heat; differences were negligible. Total buffering capacity was high for alfalfa, oat hay, and almond hulls; low for barley and oat bran; and intermediate for beet pulp and wheat bran. Physiological buffering capacity was consistently lower than total buffering capacity, but differences varied among and within feeds. Moisture had little effect on buffering capacity, NDF, ADF, or lignin. Time of heating had a significant effect on buffering capacity, NDF, ADF, and lignin but not on N or ash. Heating increased buffering capacity in most cases. Lignin was a poorer predictor of buffering capacity than total ash across feeds but a better predictor within feed across treatments. Large errors could occur when using total ash to predict buffering capacity for feeds subjected to heat.

Key Words: buffering capacity • heat • moisture

Submitted on October 2, 1991
Accepted on December 12, 1991

This article has been cited by other articles:

				J. A. Renteria-Flores, L. J. Johnston, G. C. Shurson, and D. D. Gallaher Effect of soluble and insoluble fiber on energy digestibility, nitrogen retention, and fiber digestibility of diets fed to gestating sows J Anim Sci, October 1, 2008; 86(10): 2568 - 2575. [Abstract] [Full Text] [PDF]